Home >> Products >> Gas-assisted parts

Auto tail gas assist mold

Auto tail gas assist mold

Auto tail gas assist mold-Auto tail is installed on the end part of car,which is used to  create A Sense
 Movement during driving.It is a important part of the beauty appearance design.it has a big size, almost the same size
as car width.The thickness wall of end adge of empennage is up to 40mm,for such big thick,we have to employee
gas assist mold craft to make it possible by injection molding.Normally we can see many many cars have empennage,
like BMW,BENZ,AUD,TOYOTA etc.

Auto tail gas assist mold general information:
1)ABS materal with 1x1 cavity,hot sprue with side gate
2)1.2344 steel with LKM moldbase.
3)Molding circle time is designed to 145s
More details information pls go to our website,or contact us directly.

Artical come from JK-MOLD,The website is www.jk-mold.com

【 Hits: 】 【 add time:2011-11-2 11:19:33 】 【 Close this page